High Amp Switches

These are the best aftermarket switches we have seen for motorcycle applications since we started toying around with bikes in 1982.   They are rated for 20 amps, NEMA approved for water-resistance, and have large soft-faced rubber paddles which are easy to operate even wearing the largest of winter gloves. 

Standard switch is configuration is on/off.  Also available is on/off/on, momentary on/off, mom on/off/mom on, and DPDT.  Switch colors available are red, amber, green and blue (3 way switches available in red only).

Interlocking mounting bezels (shown above) allow installer to make clean looking installation and have to cut only one hole for multiple switch installation.  Available in end, centeror single positions. 

How to determine how many bezels you need;
For a 1 position mount, use 1 single bezel.
For a 2 position mount, use 2 end bezels.
For a 3 position mount, use 2 end bezels and one center bezel. 

You can fit 3 across any of our >Fairing Replacement Panels (shown above, not included).  In fact, if you order switches with bezels in your panel, we will install them and daisy-chain the grounds at no charge! (Gold Wings only).

Blank panel (shown above on rightposition) allows room for future growth.