| Remove both the turn signal lenses and
bulbs. At the socket base, there are 2 phillips
head screws. Remove these.
Remove the 5 allen head screws on the inside of the
fender that secure the light to the fender. |
|
| Unplug the wires behind the light.
Twist the license plate light and remove it.
Lift the light up and away from the fender. Rotate it 180 degrees so
that the back of the light is visible. Lift the light and place a soft
cloth on the fender and then let the light fall back against the fender.
Remove the allen head screws shown in the photo to the
right. This will allow you to remove the turn signal stem from
the base. |
|
| Place a soft cloth on your work surface.
Place your signal stem on the cloth. Remove the clip that secures the
stem to the round housing. This clip is inside the housing where the
wires go into the stem. Pull the housing off the
stem.
Pull the wire seal out of the stem. You can now
run the wire thru the housing into the stem. |
|
| Leave an inch or two of the wire outside
the housing so that you can plug and unplug the LED array. |
|
|
Photo shows LED array placement in the lens.
The silicone light requires no adhesive. They
simply use friction.
|
|
Wire color codes:
tail light = blue
brake light = yellow
left turn = brown
right turn = green
(be sure to double check this info)
|
|
