home / lighting / turn signal conversion kits / stem housing / straight in bulb

Turn Signal Conversion Kit Stem Mounted Housing Style Bookmark and Share

click on image for larger picture

Priority of illumination as follows
(first is highest priority & overrides all others):

1.  Turn Signal (amber)
2.  Brake Light (high intensity red)
3.  Running Light (low intensity red)


Fitment: universal - p/n 01314

 

 

 


Think of this - your rear turn signal housings are illuminated only when the turn signal is flashing.  These are dead lights the rest of the time.

Our signal kits simply, easily and legally:
-
make those dead housings additional red running & brake lights the rest of the time.  
-TRIPLE  the size of your rear running and brake lights without adding any additional housings.
- do not alter the operation or components of the stock turn signals.
-
shut off the red light in the signal housings when the amber signal comes on.

Other kits make your signal lights into running lights and signals, but in amber:
- ILLEGAL on any motor vehicle and much more expensive than our kit.
-
NO  brake lights!

No dying or replacement of the lens is required either with our kit.  Not to mention that amber turn signals are much more noticeable.

The kit is comprised of two LED rings with 12 LEDs each.  The pc boards are epoxy sealed after the LEDs are soldered in place to seal the board and secure the LEDs to the board.  We also include two run/brake circuits that make the rings multi function.  The rings sit on the actual bulb using a special silicone grommet designed to handle the heat your bulb creates.

>Click here for a video of the kit in action!

Roadbike magazine did a review of the kit - >click here to see a pdf copy.

$49.95